Advice6 min read
How to measure a door opening: width, height, wall thickness
How to measure the width, height and wall thickness for new interior doors. Opening sizes by manufacturer, left-hand or right-hand doors, and mistakes that cost money.
This text was machine-translated from Slovak and is awaiting review by a native speaker.
We are here to help
Don’t know the opening size?Measuring guide →Already decided?Door configurator →Would you rather call? 0907 085 086 or info@idvere.sk.
Quick table: which opening, which door
Door width is given as a nominal size (60, 70, 80, 90). The wall opening is always wider, because the door frame has to fit into it. Each manufacturer gives its own recommended opening, and the frame architraves only cover an opening up to a certain width:
| Door | Recommended opening — Erkado, iDvere | Recommended opening — Invado | Architraves cover an opening up to (Erkado 6 cm / Invado 60 mm) |
|---|---|---|---|
| 60 | 68.8 cm | 67.4 cm | 74.6 / 74.4 cm |
| 70 | 78.8 cm | 77.4 cm | 84.6 / 84.4 cm |
| 80 | 88.8 cm | 87.4 cm | 94.6 / 94.4 cm |
| 90 | 98.8 cm | 97.4 cm | 104.6 / 104.4 cm |
| Standard | Door leaf height | Opening from finished floor level | Architraves cover up to |
|---|---|---|---|
| Slovak — Erkado, iDvere | 198.3 cm | 201.3 cm | 204.2 cm |
| Slovak — Invado | 198.8 cm | 200.8 cm | 204.3 cm |
| Polish PL2112 — Erkado only, made to order only, surcharge of 15% of the set price | 211.2 cm | 214.2 cm | 217.1 cm |
Porta does not give opening or door leaf sizes in its price list — for Porta doors, we will check them before you order. An opening that does not match any of these sizes needs to be adjusted.
What you will need
- a tape measure,
- a pencil and paper,
- for several rooms, a list of the rooms, so that you do not mix up the measurements.
When to measure
Measure only when the plastering and the floor are finished. Manufacturers give the opening height from finished floor level, and doors are installed only after the finishing work on the walls. If the floor is not laid yet, find out its thickness, including the adhesive or underlay, and allow for it.
Step-by-step measuring
1. Opening width: in three places
- Measure the width from plaster to plaster at the top, under the lintel.
- Measure it in the middle of the opening height.
- Measure it at the bottom, just above the floor.
- Write down the smallest of the three values. Use it to choose the door width in the table above.
Walls are often not parallel, so the narrowest point decides.
2. Opening height: in two places
- Measure the height from the finished floor to the lintel on the left side of the opening.
- Do the same on the right side.
- Write down the smaller value.
Neither the floor nor the lintel is necessarily level. The door standard is chosen by the opening height — see the second table above.
3. Wall thickness: in three places, including tiles
- Measure the wall thickness in the opening at the top, in the middle and at the bottom.
- Measure from surface to surface, including plaster. If there are tiles on one side (bathroom, WC, kitchen), the measurement must include the tiles and the tile adhesive. If the tiles are not on yet, add their thickness.
- Write down the greatest value.
The adjustable lining frame is chosen by the wall thickness. The manufacturer supplies it in sizes, each of which covers a certain range of wall thickness (for example Erkado C 120–140 mm). The greatest measured thickness decides. If the thicknesses vary a lot from place to place, call us before you order.
4. Left-hand or right-hand door
- Stand so that the door opens towards you.
- Look at where the hinges should be.
- Hinges on the left = left-hand door. Hinges on the right = right-hand door.
5. Write down the room too
For each opening, note which room it leads to. The lock is chosen by room: usually a WC lock (bathroom privacy lock) for the bathroom and the WC, a BB lock (standard warded key) for the other rooms, or a PZ lock for a euro cylinder. For in-stock doors, the set price includes a WC lock for the 60 cm width and a BB lock for 70–90 cm; changing it costs a surcharge. For made-to-order doors, the price includes the lock of your choice.
You can choose any finish for a bathroom. On humidity, the manufacturers state: Porta — normal conditions of 30–60% relative humidity, and the door must not come into direct contact with water; Erkado — the ST CPL and CPL finishes are also suitable for rooms with higher humidity.
How wall thickness becomes a frame letter
Manufacturers mark the sizes of adjustable lining frames with letters. Each manufacturer has its own ranges, so the same letter does not mean the same wall thickness at Erkado, Invado and Porta. The price bands also depend on the manufacturer:
| Manufacturer and frame | Price bands (wall thickness) |
|---|---|
| Erkado rebated, in stock | A–E 80–180 mm, F–K 180–300 mm |
| Erkado rebated, made to order | A0–E 65–180 mm, F–K 180–300 mm |
| Erkado flush | A–F and G–L (Altamura 1 in stock: 80–315 mm) |
| Invado rebated | A–E 75–179 mm, F–K 180–299 mm |
| Porta rebated | A–E 75–180 mm, F–K 180–300 mm |
| Porta flush | B–E 95–180 mm |
| iDvere | 80–180 mm and 180–300 mm (no letters) |
The F–K band is more expensive (for example Frézia 1 in stock). The Erkado catalogue gives the sizes in mm; we assign the letters to them according to the manufacturer’s table.
You do not have to look up the letter yourself. Enter your measurements into the measuring guide, and for each model it will tell you the frame size according to that model’s manufacturer.
The most common measuring mistakes
- Measuring before plastering or laying the floor. The opening then gets smaller, and a door sized to the bare shell will not fit.
- One measurement instead of three. The width at the top and at the bottom can differ. Write down the smallest.
- Wall thickness without the tiles. The frame will then not cover the edge of the tiles.
- Confusing the opening width with the door width. A size 80 door does not need an 80 cm opening, but 88.8 cm (Erkado) or 87.4 cm (Invado).
- Left and right from the wrong side. Always look from the side where the door opens towards you.
- Height from the concrete instead of the finished floor. Without the floor thickness, the door turns out taller than the opening can take.
If you are not sure, take a photo of the opening with a tape measure held against it and send it to us. We will check the size before you order.
Doors in stock in standard widths
These models are in stock in widths of 60–90 cm and in the Slovak standard.
- In stock25 decors
Erkado · FréziaFrézia 1in photo dub stset from€350within 7–10 working days*
- In stock24 decors
Invado · Linea ForteLinea Forte 5in photo dub európskyset from€240within 7–10 working days*
- In stock32 decors
Invado · Norma DecorNorma Decor 1in photo lindo bielaset from€192within 7–10 working days*
Frequently asked questions
What opening do I need for a size 80 door?
Manufacturers give a recommended wall opening: Erkado and iDvere 88.8 × 201.3 cm, Invado 87.4 × 200.8 cm (height from finished floor level). The frame architraves cover an opening up to 94.6 cm wide (Erkado, 6 cm architrave) or 94.4 cm (Invado, 60 mm architrave). Porta does not give opening sizes in its price list — for Porta doors, we will check the size.
Should I measure before the plaster and floor are done, or after?
After the plaster and the finished floor — manufacturers give the opening height from finished floor level. If the floor is not laid yet, allow for its thickness, including the adhesive or underlay.
How do I know whether I need a left-hand or a right-hand door?
Stand so that the door opens towards you. If the hinges are on the left, it is a left-hand door. If they are on the right, it is a right-hand door.
My wall has a different thickness in each place. Which value should I enter?
The greatest one you measured. A manufacturer’s frame size is a range of wall thickness (for example Erkado C 120–140 mm), and you choose it so that the frame also covers the thickest point of the wall. If the thicknesses vary a lot from place to place, call us before you order.
What if my opening does not match the table, for example it is 86 cm?
An 86 cm opening is wider than the frame architraves of a size 70 door can cover (84.6 cm Erkado, 84.4 cm Invado), and narrower than manufacturers recommend for a size 80 door (87.4 cm Invado, 88.8 cm Erkado). Such an opening needs to be adjusted. Send us a photo of the opening with a tape measure held against it and we will advise you.
I am keeping an old steel frame. Is it enough to order just the door leaf?
Send us the clear width and height of the steel frame and a photo. We will check with the manufacturer whether ordering just the door leaf is enough, before you place your order.
Prices and availability are from the current price list, updated 12 November 2026.